Physical Installation Procedures:

Connecting the Recording Equipment

Connect the EnVR/Bridge to a single switch to keep the camera traffic segmented from the rest of your location’s network traffic. Label all cable ends at the head end for ease of troubleshooting.

Depending on the network configuration, either the second physical network interface of the EnVR/Bridge or the switch’s own uplink will connect to the local network’s router or switch for Internet access.

Note: Do not connect other devices or computers to an Envysion provided switch.

Recommended Installation Equipment Checklist:

IP Only Set Up:

• Monitor
• Keyboard
• Cat 5/Cat 6 patch cables (min 3’)
• Cable manufacturing tools
• RJ45 connectors 
• Cable tester
• Punch down tools
• Basic hand tools (Screwdriver, hammer, pliers, torx security driver & bits, etc.)
• Caulk and caulk gun
• Battery powered drill & bits
• Cat 5 / Cat 6 cable (as needed)

Analog/Hybrid Set Up:

• Monitor
• Keyboard
• Cat 5/Cat 6 patch cables (min 3’)
• Volt meter
• Spot monitor
• Basic hand tools (Screwdriver, hammer, pliers, torx security driver & bits, etc.)
• BNC connectors
• Cable crimper
• Siamese cable
• Cat 5 / Cat 6 cable (as needed)
• Caulk and caulk gun
• Battery powered drill & bits